%ProgramFiles%\Microsoft\Exchange Server\GroupMetrics\ %ProgramFiles%\Microsoft\Exchange Server\Mailbox\*.* The following list/locations is recommended by Microsoft for Microsoft Exchange server: You can do so from Client Settings > Manage Policies section. If your system on which Microsoft Exchange Server is installed, is in a different group that has some different policy applied, then you need to configure the above mentioned settings for that policy.The steps mentioned above are applicable to the default policy of Seqrite Endpoint Security.Under Exclude from, select Known Virus Detection.Exclude File(if you select this, follow the step below).Type the folder path in the Enter folder path.Exclude Folder(if you select this, follow the steps below).On the Exclude Item screen, select either of the following (Exclude Folder or Exclude File):.Under Exclude File and Folders, click Add.On the Settings screen, click Scan Settings.Log on to the Seqrite Endpoint Security web console click the Settings tab.Note: After you have installed Seqrite Endpoint Security on a system running MS Exchange, as a first step you must follow the guidelines and instructions listed below to exclude files and folders recommended by Microsoft. These configurations involve excluding certain directories, and file names from file-level scanners. Microsoft has recommended configuring trusted zones for security solutions, which if not done correctly can give rise to issues such as system getting hanged, slow or non-responsive. If so, then the Firewall can block the communication between Agent Server and Client Agent. Please check if any Firewall service is installed on the system. Suppose the IP address of the remote system is 192.168.100.8 is the port on which the Client Agent is listening, then execute the following command on Endpoint Security Server. If you receive any response from the Agent Server, check whether the Agent Server is able to communicate with the Client Agent. Then execute the following command on the remote system. is the port on which Agent Server is listening. Suppose IP address of the Endpoint Security Server is 192.168.100. Verify if the Client Agent Service is started on Remote System.Verify if the Agent Server Service is started on the Endpoint Security server.This problem can be resolved in any of the following ways:Ĭheck if both the Endpoint Security server and Remote System are able to communicate with each other on the configured port. The Client Agent is not able to connect to the Agent Server OR vice versa.Subnet Mask of the Remote System should be as per the IP class assigned to the Endpoint Security server system.In this case, bypass the Proxy Settings for the Endpoint Security site. If Internet Connection is configured using Proxy Server, it may not be able to resolve the name or IP of the Endpoint Security server.In Services, check the Client Agent Service status is 'Started'.Verify if the Client Agent Service is started on Remote System. In Services, check the Agent Server Service status is 'Started'. ![]() Verify if the Agent Server service is started on the Endpoint Security server.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |